If you leave Check axial allowance blank, the value for Check allowance is applied to axial and radial check surfaces. If you enter a value for Check axial allowance, the value for Check allowance is applied to radial (XY) check surfaces only. Set Check surfaces on the Dimensions tab.Ĭheck axial allowance - Enter the amount of axial (Z) material to leave on a check surface. You can enter a positive or negative value. If left blank for a finishing pass, the Leave allowance value is used. If left blank for a roughing pass, the Finish allowance value is used. Positive numbers offset the toolpath towards the tool holder, negative numbers away.Īxial tolerance - This helps to stabilize the tool axis and reduce tool load.Ĭheck allowance - Enter the minimum distance that you want to leave around check surface(s). Axial offset - This attribute offsets the lowest position of the toolpath along the tool axis.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |